I just picked up a TC45DA and have a couple of questions
What are the two switches to the right of the operators station for?
What does the designation "DA" represent?
Thanks
Working on a kubota L4350 tractor I believe the loader is a La950.
I have lost pressure to the bucket in the down position. It slowly goes down but very slowly.
The float control still works and the bucket will free fall.
This tractor is also equipped with a hydraulic side and toplink
thank you
Looking at a used Kubota 3130 4x4. Tractor has about 250 hrs on it. There is a light of a wrench on on the dash. I assume it to be a service or check engine light.
Everything on the tractor seems to work but this light worries me.
Any ideas?
I have a B21 TLB and the 4wd is inop. The front driveshaft spins and I can hear something rattlling around in the front axle
Any idea of where to start?
Working on a kubota L4200 dt. I have worked on numerous tractors just not one of these. I have adjusted the clutch rod both ways to the maximum but the pto does not disengage
Is this a two stage clutch? Do I therefore need a clutch?
The transmission disengages just not the pto.
The pto...
I have been searching for the fluid level check for the hydraulic/tranny etc on an older kubota L 2850. The fill plug is in the rear above the three point bu i do not see a dipstick or sight glass anywhere