Recent content by DLMaine01

I am going to look at a Super Apache Chipper. Owner says 3" capacity and is running it with a "43" hp Kubota. I will assume a 4330 or 4310. I would run on a Kubota M4900. I am hopeing its Cat I. My main use is grinding sweet corn culls and stalks for cows. Plus a small amount of 3" or less brush...

I have a lead on a John Deere 336 square baler. I have heard good things about them here (FWJ) and from others elsewhere. But what do I look for in a used unit? I will ask the presant owner to make it run, but where are the ware points? Any help appreciated. Thanks! Dave

My new tractor was delivered without a hitch. I was a little worried about buying from a distance but it all went like clockwork and I saved in excess of $5000.00. I have only 4 hrs on it but it is great. The 5 cyl. just purrs, the transmission is very smooth and I love the hyd. independent pto...

Well I finally did it. Will be going from a 1985 L2250 to a New 2005 M4900 4WD ROPS with LA1002 FEL. Local dealer was not even close on price even with shipping so tractor is coming out of KY. At first I thought I would keep the 2250 but as I have only enough inside space for one tractor I...

Hi All Just got a engine block heater for my L2250 Kubota tractor. It is the factory freeze plug type. How do I remove the freeze plug from the block? Also they recommend that it be installed in the center plug, well that is behind my starter which I would rather not remove unless necessary. So...

I should have cut these tree before I built the house but you know how that goes. They did lean quite a bit twords the house and am glad to have them gone.

I called and ordered the HD top link bracket from my dealer today. The price was $65.00. I will fax him the other part numbers for bolts washers and spacers on Monday. I got the part numbers from an old post in this forum . Another old post suggested that you need to weld the original bracket...

Fianally decided to get the Tajfun winch. It was the dealer as much as anything. I hope it lasts as long as the Farmi's seem to. Had to shorten the pto shaft a bit (per the manual) to make it work. The manual was a little light on info on hooking up to the tractor. I have the top link in the...

I want to add a Farmi Log Winch to my Kubota L2250. Two models would work, the JL290 17-30 hp and the JL351 20-40hp. My pto hp is rated at 21. Would the JL351 work my tractor to hard? I do hope to upgrade in the future to a larger tractor but for now the 2250 is it and I have and I have lots of...

We bought a 2250DT this November so this is our first winter with it. The manual says to energize the glow plugs for 30 seconds or so and then try and start. It never starts on the first try but always on the second or third try. Is this normal? The outside temp is between 10 and 20 degrees F...