Recent content by EndlessMowing

Well , I can happily report that my MF135's position control works like it should without using the draft control lever improperly. Adjustment, proper adjustment and more adjustment by a local tractor repair shop Originally, as most, I had to use the draft control lever to "get by" but after...

I have the tri star pattern wheel bearing hub covers. On the 135, How big an opening do I need on a pipe wrench to get these off? Pretty sure the 14in I have is too small. I hear urban legend of a spanner for this type but see nothing to purchase. Thanks.

Need to know if This part needs a Gasket? 135 Hydraulic Cover Cap. Every parts place is closed closed right now and description doesn't say. Massey Ferguson 135 Cover Cap (180908M1) Old one someone had welded up the threaded port and it appears the weld or the base of my plate is leaking now...

30-33 to 240? Just curious what you all see as the typical ohm reading on a late 60's 135 diesel fuel guage, USA made I haven't had time to measure it with the meter, since the tractors stored quite a way's away from me, but see two were available. Theres a SW (stewert Warner I assume)...

MF 135 perkins 3 diesel 6 spd Ground, neutral, Engine PTO I'm wondering what's normal here with this newer to me tractor. Dual Clutch when fully pressed allows me to engauge the "Engine" PTO lever like you'd expect, (bush hog) takes off pretty quick after letting up on clutch. Problem, or...

I did it, I cracked the end cap of the horizontal 2 part air filter box, screwed the cap on a little cock eyed, and gave it a tap of the fist and SNAP :mad: Massey 135 I have been searching parts suppliers online and can't seem to find the cap for sale, any help with a link, or someone willing...

I've been looking at several vendor websites trying to find a reasonable tachometer (3 cyl Perkins Diesel) and appropriate gauges for my MF 135 I have seen NUMEROUS variations of gauge placement on the internet, is there a "standard" as to where they went? I only have 3 gauges, plus the tach...

Recently purchased this 135, and was wanting to pick the brains of the forum as to the, orginality pieces missing items that are currently used that may be better, etc of this 3 point set up. I realize, and have found several little "fix it's" to keep the tractor working, and mainly wanting to...

Brought this home couple weeks ago for grass mowing duties as well as some minor box blading. Not exactly sure the year of manufacture, the plates missing and I plan to remove the paper air filter canister to see if the alternative serial number location is near the battery tray. Particulars...

Just joined, been shopping for a MF135 and had a question about seat height before going further There's 2 style seats I see most often. Bucket type - with seat pad and thin back pad. AND Arm rest spring tensioner type. Main question is - does the bucket style seat sit lower than the arm...