Recent content by gimmodog

  1. G

    Stories of how you came about your property

    Thieves and drugs were getting bad in the county I was living in. My son had built a house in a town ruffly 40 miles away. He had a son that was 2 yrs old and we didn't get to see them much so we decided we would start looking for a few acres outside of the that town. As a joke he sent us photos...
  2. G

    B2920 won’t start

    Re: B2920 won稚 start now that you have a meter we can guide you on how to troubleshoot to find the problem. Using this schematic. I HOPE THIS IS THE CORRECT SCHEMATIC, it is the one posted earlier set you meter to the lowest voltage setting above 12 use a jumper to connect the negative...
  3. G

    b2910 flasher/hazard fuse shorting out

    I thinking you fixed the problem by repairing the 2 stripped wires. looking at previous diagrams posted the brown wire ran from the flasher to the switch which would have voltage on it. with it and the black (ground) wire being stripped that is where it was passing the excess current.
  4. G

    b2910 flasher/hazard fuse shorting out

    then I did misunderstand your reading of the right side of the fuse holder. I would think the the meter would read 0.00 when turned to 200 ohm and leads not touching anything. I have not used many different types of meters so it could be an I for infinite just never saw a meter read like that...
  5. G

    salvaged a Clark forklift...

    good to see ya saved it that looks like a '65 or '66 Galaxie behind your son. I have a '67 Galaxie convertible that my father had since the mid 80's. still original and looks great. I got it after he passed in '05
  6. G

    Ford LGT16D 48" deck gearbox seal leaking

    I bought a Ford LGT16D a couple months ago and have now found out that the deck gearbox is dry. It must have a seal at the bottom of gearbox. Has anyone ever had the gearbox on the 48"deck apart? I will have to replace the bearing and seal. I haven"t taken it apart yet. Looking for any advise...
  7. G

    JD 4200 fuel injector pump problem

    housing pic is a little blurry but each pic I took was blurry . I can see the barrel housing circulars in the housing casting and neither of them look damaged It looks like there is no damage to the housing. I had it filled good with aero-kroil and did not have to tap very hard for the barrels...
  8. G

    JD 4200 fuel injector pump problem

    My JD 4200 has sat for a couple of yrs and now when I tried starting it it has no fuel coming out of the injector pump. It ran fine when I parked it. It has the Yanmar 3TNE78A-JT42 3 cyl engine. I do not think this is an air problem. I have installed an electric fuel pump so I know it is getting...
Top