Recent content by glkingar

  1. G

    Parking brake problem TC33D

    I've been having a problem with my parking brake not working lately. Crawled under and discovered that only part of teeth lined up with the pawl and those teeth are worn down. Anyone had to deal with this?
  2. G

    Need advice/help on a 2003 TC33D I just bought.

    Not sure where to steer you about the steering problem but the attached should help clear up the fuse questions and some troubleshooting steps for the panel. Hope this helps. Gerry
  3. G

    hose failure cleanup

    I've tried to search for a previous post but apparently the android TBN app doesn't do that very well. As the description says I had a hose failure that sent hydraulic fluid everywhere on my tractor. What is the opinion of the awesome TBN brain trust on how best to get this mess cleaned up...
  4. G

    Can't loosen steering hose fitting

    Hi Everybody, I have 2004 New Holland TC33D and the hose that runs from the inboard end of the right hand steering cylinder has a hole worn into it. Tried to remove it today and can't budge the connector at all. Worried about damaging the connector cap. Do you need to use flare nut wrenches...
  5. G

    ignition switch problem with TC 33D, 2003

    Welcome to the forum. Hope this drawing helps. Gerry
  6. G

    another tire loading question

    Hi Everyone, Yet another tire loading question. :rolleyes: I have been searching the forums but could not find an answer to my question. I had some kind of blue tire sealant added to my tires a few years ago and my question is: Is that going to be a problem when I load my tires? I usually use...
  7. G

    Exhaust Removal System

    Has anyone built an exhaust removal system? My tractor and vehicles are in a garage that doesn't have great ventilation. There is a window in one end and the rollup door on the other. Would like something that would go over the end of the exhaust and take the exhaust out of the building...
  8. G

    Seal Replacement

    I have TC33D with Supersteer and the rear boot seal of the steering shaft is torn. From the parts diagram it looks like all you have to is remove the cotter pin and the nut above the mounting plate and it should drop down and be able to replace the boot seal. Has anyone done this? Can you get...
  9. G

    you are burning a dual-layered disc

    Glime you do realize this a tractor forum right?
Top