Recent content by holt50

check your ground cable or cables ,theres some corrision somewhere

hey there I 'm about 100% sure that that is a 4 cylinder engine , might want to check again however I could be wrong

I have a JohnDeere 5310 tractor 4 wheel-drive and I changed hyd. oil and filter and pulled out the screene from behind the tractor cleaned and I started to put the screen back in and put my hand inside housing to clean and I got a short piece of metal it looks like a dowl pin about three-eights...

I have a 4000 ford farm tractor plain jane large frame and the loader won't raise hardly at all ,the pump has been rebuilt and I am thinking it might be sucking air somewhere ,could this be the problem and if so where would it be sucking air? any suggestions holt50 email is...

I have a 4000 ford plain jane tractor large fram and the hyd.don't work hardly at all ,the pump has been rebuilt and it's slow slow and slow 'the loader don't tilholt very good either coul it be sucking air and if so where might it be? holt50 thanks

hey there I am trying to install a valve selector with selionoid on my 585 case in order to operate a hyd. top link and another cylinder at same time or one after another however I ordered the selector valve from surplus center it doesn't have instructions , can i put quick-disconnects on this...

I AM NEEDING A 3 SPOOL AND ONLY HAVE 2 , I HAVE A GREAT-BEND 330 LOADER 2 SPOOL AND WANT A GRAPLE ,DO I NEED TO CHANGE THE WHOLE 2 SPOOL TO A 3 OR CAN I ADD 1 SPOOL TO THE ONE I CURRENTLY HAVE AND HOW . I AM NOT THE BEST WITH HYDS. WHAT DOES THE LETTERS P-W-B-Y-D STAND FOR WHICH IS ON A PLUG ON...

I have a C-70 McCormick tractor two wheel drive no cab, does anybody know how to get some instructions on adjusting the clutch cable that comes from the rear of tractor under the running board and to cultch pedal , does not want to go in gear until I pull out on the cable have adjusted it as...

If you're out there and have a c70 McCormick tractor have you had any problems with it changing gears? Mine doesn't want to change when i take it out of low high or reverse it won't go back in any of the ones mentioned. Ibushoged and I probably messed with the cable that goes from rear to clutch...

has anybody had any trouble shifting gears [ the low high and reverse ]I NEED a few directions for adjudting the cable that comes from the rear -end and goes to clutch pedal , I did some bushogging and briars work on cables any help will be appreciated holt50

I HAVE a 5400 vermeer round baler 4#5 bale and I pull it with a c-70 McCORMICK tractor and it pulls the hound out of me what do I need to look for ,I know the first would be a bearing ,can't find none that needs replacing most of the time a bad bearing will find you, gear box is full and so on...