Recent content by Inkomodius

Hey, Was wondering if anyone has some experience with wire feeders running off an engine drive. My issue/s are: I have a Miller Trailblazer 325 EFi and a Miller 12rc (non voltage sensing) Wire feeder. For the first few days it ran great, but now when I go to initiate an arc off of low idle...

Hey friends, Haven't been on here in forever however your the first people that I thought of haha. I need to put a non flame cut 3" hole in 2.5 inch of plate. Its 1" plate on either side of a 1/2" web on wide flange. So as long as the holes are accurate I can do each plate individually. So far...

Hey I have 16 machines (delimbers, feller bunchers and excavators) to cork (or weld on ice lugs) next week. I've done quite a few however this company is asking for a procedure on it. I've never seen or been asked for a procedure and I'm not going to pay to have one engineered. I've always had...

Ive done a lot of cutting edge install and replacement on bucket's graders ETC. I know our steel classification in Canada is different then the states. But here an AR steel is an atmospheric steel usually used on bridges where it doesn't need to be top coated, It has higher amounts of nickel in...

Todd do you have any plans on opening a Canadian distribution channel? It would make us Canadians more apt to order products as well as you would have a huge market pretty much to all your selves as the implement area for compact tractors is substandard. Just an FYI. ;)

Ok lets here some ideas for homemade tractor presents. I need ideas to make for my brothers NH TC30, I already made him a 3pt reciever, hooks for the bucket, and am in the process of building a light mount for his ROPS. The limit is 50 dollars, so small ideas? I pick up my new welder tomorrow...

Any one own one, or ran one? Im looking at a YC35 with a cummins engine. I live in a "remote" part of canada. I know cummins mechanincs but as far as hydraulics go, how readily avail are they? Also has anyone in canada dealt with JDB equipment? I was looking at a JD 110 tlb but like the idea of...

To all the people that bought hoes or TLB's can you honestly justify the extra 10-14k (Canadian) for the attachment. I think if i had one id use it but for all the things I need to do i dont know if i could justify it. I can rent a Cat 308 for 1800 a week 0r 3500 a month. What I have to do Is...

Does anyone know where a guy can buy blank cutting edges online or in canada? western canada preferably?

Hey all, new to TBN, dont have much internet access up here. Im looking at a 4720, pretty much have it narrowed down to that, however it says its a 58hp, however if you look at the spec sheets for the 4x20 series now all the horse power rating went up. It shows the the 4720 @ 66hp and 56pto now...