Tab Content
  • Jeepnford's Avatar
    Today, 01:14 PM
    Jeepnford replied to a thread Mig or stick? in Welding
    From what I understand 7018 might be the best choice but my understanding is pretty limited. In the end if the welds are good it's probably cake.
    60 replies | 1883 view(s)
  • Jeepnford's Avatar
    Today, 01:02 PM
    Jeepnford replied to a thread Stick welding question in Welding
    I did some stick welding last night with my big shop fan about 4 feet behind me and my fume extractor running. The only way I could see anyone moving...
    7 replies | 136 view(s)
  • Jeepnford's Avatar
    05-25-2018, 12:10 PM
    When I built my water-wood stove I figured it weighed about 1600 lbs. I lifted it with my DX35 without the bucket attached. I only had to move it...
    19 replies | 432 view(s)
  • Jeepnford's Avatar
    05-25-2018, 08:28 AM
    Jeepnford replied to a thread Mig or stick? in Welding
    I'm going against the grain but when I started welding I was taking some classes and they usually start you on gas and stick. I did fairly well on...
    60 replies | 1883 view(s)
  • Jeepnford's Avatar
    05-22-2018, 09:18 AM
    The 2000 lb is rated at the pivot pin, the farther out the load is the less it will lift. I don't know what the bucket weighs, 200 lbs.? I would try...
    19 replies | 432 view(s)
  • Jeepnford's Avatar
    05-08-2018, 06:22 PM
    FM504 said portability wasn't an issue for his uses, not me. Everyone has their own opinion.
    16 replies | 1297 view(s)
  • Jeepnford's Avatar
    05-07-2018, 12:21 PM
    You might try looking for a used Miller Thunderbolt or Lincoln Tombstone transformer machine with DC capability for a stick welder. Usually one or...
    16 replies | 1297 view(s)
  • Jeepnford's Avatar
    05-03-2018, 11:34 AM
    Jeepnford replied to a thread New to welding in Welding
    Do a web search on stick welding electrode charts. They will give specs on the different rods. Also, if you're a youtuber, look for channels from...
    16 replies | 832 view(s)
  • Jeepnford's Avatar
    04-30-2018, 12:33 PM
    Continuous welding depends on your output. If the machine is not labeled with duty cycle you can probably look up a manual for that model on Lincolns...
    18 replies | 944 view(s)
No More Results
About Jeepnford

Basic Information

About Jeepnford
Location (City, State):
NE Missouri
What Make/Model of Tractor Do You Own?:
Case DX35
Attachments:
FEL,Snow Plow,Box Blade
Hours:
500

Statistics


Total Posts
Total Posts
305
Posts Per Day
0.09
General Information
Last Activity
Today 02:04 PM
Join Date
09-07-2008
Referrals
0
© 2018 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.