Recent content by jeson

Yes! Now I Will just have to find 2 oil seals - not so easy to come by in these sizes here in Denmark.... [emoji50]

Got it! The bolt is conical and you just have to remove the nut from one end and tighten it at the other end - then the conical bolt slips out! Simple - but it took me at while to figure it out :-) Regards Jesper

Hi, I have just split my Ford 4000, because the clutch needs to be replaced. But now I can see the gasket behind the front support plate is leaking oil. Well - not a big deal - just got to put in a new gasket! But I can't figure out how to dismantel the clutch release fork!!! I can't find any...

Hi, My Ford 4000 runs fine, but a couple of times in the last weeks it suddenly stops... When I try to start again nothing happens - the motor turns but it dosen't fire. Because there's no smoke at all I think it dosen't get any fuel. So I try to bleed the fule pump and it starts and runs fine...

Hi, Some years ago I built a play ground for the kids out of some oak logs that I collected in my wood. That was a major succes - the children loves it! But I didn't remove the bark and didn't treat the logs with anything, so now it's beginning to rot. Today I collected some new logs (pretty...

Hi, I have an old TEKKER VHI260 Welding machine. It runs fine but I would like to know more about the machine and the TEKKER brand. Anyone knowing something about this?

Hi, I have no hydraulic return connection on my Ford 4000 (1969, 3 cyl. disel). Where do i place the quick connection for the return oil? Regards Jesper

Hi, I have just bought a '69 Ford 4000 and a trailer. Mostly for use in the forrest. I like everything with a motor in it, and hope to get some answers from the forum while I'm repairing my different machines...