Recent content by LarryP

I was driving my Satoh 630 Diesel and it just quit. I pulled the fuel lines off, at the top of the block, and turned over the tractor and no fuel squirted out. Next I removed the injector pump, which looked fine, and then looked inside the engine block and all parts were turning. Any suggestion?

I am looking for 2 adjustable lift arm adjusters. If I can not find them, then I need to find some threaded rod and a turnbuckle so that I can make them myself. Thanks Larry P

I'm looking for 2 hydraulic cylinders for my tractors. Extended length is 50", cylinder length 25", shaft 1.25". The ends are 2.5" long, runs perpendicular to the shaft, and has 5/8" to 3/4" hole. Thanks

I'm looking for 2 hydraulic cylinders for my tractors. Extended length is 50", cylinder length 25", shaft 1.25". The ends are 2.5" long, runs perpendicular to the shaft, and has 5/8" to 3/4" hole. Thanks

I need to adjust the clutch. The clutch is releasing at the top of the pedal. I believe that you adjust the clutch by adjusting the rod between the pedal and clutch. Is this right and which way does it need to move . If not HOW???? Thanks Larry P

I have cleaned the filter, replaced the spooler value and the front buck hydraulics is still week. The bucket, once full, will drop once you let off of the lever. What do I check or replace next? Thanks Larry Peaster

I have a S630D tractor and I need to be able to move my lift arms higher so that I can use a posthole digger. I'm looking for either (2) adjustable lift arm levelers, or turn buckles and threaded rod so that I can have some fabricated.

I have a S630D and it is time to rebuild the clutch. I'm looking for some place to send the clutch/pressure plate to be rebuilt. Any suggestions Larry Peaster

OK I changed the oil and cleaned the filter, at the bottom of the reservoir, and the front bucket lift is very week. Is there anything else that I can do before I have to work on the hydraulic pump. If this is my only option is there rebuild kits out there or do I have to buy a new or rebuilt...

It seams that the hydraulics are getting weaker. The bucket will delay before it starts to lift, it will lift slowly, and it may drift down once it is raised. I have to rev the tractor in order to lift the bucket. HELP!!!! I am also looking for a 2 lever bucket control. Thanks Larry

I am looking for a service manual or shop manual; new, or reprint, or copy; for a Satoh S630D tractor. Thanks Larry

I have a Satoh 630D and my PTO arms is slowly lowering , usally takings several minutes or longer to lower. Is there a filter that I need to clean on the hydraulic system or is there something else wrong with it? HELP!!!!!

I am looking for a Mitsubishi part #67475-00702 Hydraulic oil filter. I also am looking for a place who can replace the screen on the old hydraulic oil filter so that I can have a spair. I am also looking for Bull decals or a complete set of decals Thanks

I am looking for hydraulic screen filter for a Satoh/Mitsubishi S 630D. The filter is located at the bottom of the reservior.