Tab Content
  • mrmikey's Avatar
    02-07-2016, 01:16 PM
    Caught a piece in the boys a few weeks back, does not feel good. Mind you I was singing tenor fo awhile....ten-or twenty octaves higher....Mike
    27 replies | 1105 view(s)
  • mrmikey's Avatar
    01-29-2016, 02:38 AM
    Not a problem cutting ends off as long as you extend the cylinder so you don't screw up the seals on the piston or the rod end of the cylinder with...
    15 replies | 1586 view(s)
  • mrmikey's Avatar
    01-11-2016, 06:31 PM
    mrmikey replied to a thread Hydraulic pump in Hydraulics
    Some of the older ones I've worked on, the end section would fit on any section so you could take the four sections down to one....Mike
    15 replies | 1448 view(s)
No More Results
About mrmikey

Basic Information

About mrmikey
Type of Member:
Homeowner (1-10 acres)

Statistics


Total Posts
Total Posts
555
Posts Per Day
0.29
General Information
Last Activity
Today 02:35 AM
Join Date
10-17-2010
Referrals
0
© 2016 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.