Recent content by Neo

Hi All, Is it possible to get OXY and ACETYLENE bottle hose adaptors from US to Euro (or Australian) connectors?... If so where do I find them and what fitting details do I need? Thanks for your help. Neo

Hi Gents, I recently picked up a JD LA120 (With a B&S CV23) on the cheap and I'm slowly restoring it. I notice there was a lot of tacky dirt on one side of the engine so when I cleaned it all up and ran the engine for a short time oil started to drip from one of the sump bolts. But this only...

Hi, Can anyone help me with these questions above??? Also, does anyone know what this adjuster and locking not does? I need to find a replacement wheel shaft seal too.... Would I be able to get this from a regular seals and bearing shop ... or is this really something special that only TT can...

Hi All, I managed to pick up a JD LA120 on the cheap because oil was poring out of the RH shaft....Turns out the shaft washer had warn straight through allowing the wheel spacer push into the shaft seal, ripping it open. The mower was just about moving when I picked it up and there was a small...

Hi All, I new wannabe welder and I like the look of the HENROB DHC 2000 COBRA WELDING/CUTTING TORCH. Does any one have any experience or comments about this torch? Many thanks. Neo

Hi All, I am working on an MTD Yardman 604 (18HP B&S, Troy-Bilt Single Speed Transmission with Variable-speed Pulley) that has me totally stumped :confused2: When I first start up (and don't touch the Autodrive Pedal) I can select forward or reverse with ease as both drive belts are not...

Hi All, I need to get the PTO and all 3 pully's off of my TORO WheelHorse which uses and Kohler Command engine with a 1" shaft. What's the best way to do this? What tools do I need? Many thanks. Neo7

Hi all, I recently picked up a cheap "for parts" mower with an 18HP Motor...Kohler Command V-Twin (CV18s) After close inspection I noticed the right hand piston did not move when I rotated the engine and there was a knock/clacking sound at one point in the rotation. So I took the head off...