Recent content by ohioboy

I've installed a solenoid selector valve on my tractor for grapple on loader. I bought it from baileynet (can't locate part no. at moment) and it was less $ than surplus center, works well, but there's a little issue... In addition to -6 inputs/outputs it has an sae-4 drain port for fluid that...

Hello all, I'm an infrequent poster, but frequent reader. I do appreciate all the info. provided here and am looking for some input. I've got a number of barnstone (30+ ton) to move/place and was planning on installing a grapple on my loader (4410 w/ 420 loader w/ 61" bucket). I'm thinking...

I am throwing this out for opinions. I need some ballast at the rear of my JD4410, but am reluctant to load the tires because of several issues: turf tracking, ease of repair, swapping b/w turfs and R1's, etc. My thought was to build a three point ballast assembly with a quick hitch...

Can someone post the procedure for changing these out? While I'm at it, how about the knuckle seals? I just bought one and would like to get at this. Thanks.

Well, I went green today. I was in the market for a tractor, actually an orange one, but ended up with green. I looked and looked for a reasonably priced used orange one. I looked at new orange ones. By happenstance I stumbled upon a 2003 4410 12/12 ePowerReverse with R1's, 5' 420 loader...

Hello all, This my first post here, but I've been lurking around about a month. I'm in need of a 30hp, 4wd machine with a loader. (Couple properties, some woods - need to skid and haul firewood, some mowing/clean up - lawn, field and brush work, and some general relatively light dirt/gravel...