Tab Content
  • ponytug's Avatar
    Yesterday, 07:15 PM
    X2 on the landscape plane. Much better for the task in question. Even if it isn't, putting a single scarifier on the 425 to loosen a problem area...
    28 replies | 998 view(s)
  • ponytug's Avatar
    Yesterday, 06:09 PM
    My brush cutter has bolts on the front wheel casters. Never lost one. Never needed to even adjust the height.
    27 replies | 1029 view(s)
  • ponytug's Avatar
    04-16-2018, 01:04 PM
    As the saying goes... "You can sell mine, when you pry it from my cold, dead hands." Seriously. Not. Happening. I might get an 1850, but it...
    27 replies | 1029 view(s)
  • ponytug's Avatar
    04-07-2018, 10:46 AM
    ponytug replied to a thread Homemade Log Grapple in Power Trac
    You just need enough of a guide / support for the grapple claw so that with both claws at their limits they pass. I would suggest that you don't...
    30 replies | 20589 view(s)
  • ponytug's Avatar
    03-31-2018, 12:46 PM
    ponytug replied to a thread Tank Oil Change in Power Trac
    YMMV, of course, but...When it comes to older seals, I wouldn't worry about a viscosity change. Changing all of the oil to all synthetic, or adding...
    26 replies | 1727 view(s)
  • ponytug's Avatar
    03-30-2018, 12:39 PM
    ponytug replied to a thread Tank Oil Change in Power Trac
    It should be about the same. The 10 is the low temperature viscosity, and the 30/40 is the high temperature viscosity. Going from 10W30 to 10W40...
    26 replies | 1727 view(s)
No More Results
About ponytug

Basic Information

About ponytug
Biography:
Learned the importance of being mechanically adept at an early age.
Location (City, State):
Bay Area, CA
Interests:
Riding, building, repairing.
Occupation:
Chief Cook & Bottle Washer
What Make/Model of Tractor Do You Own?:
Power Trac PT1445
Attachments:
LMB, 4N1, Tiller, Trencher, Forks, Hitch plate, Brush Mower, spreader, Post Driver, and WoodMaxx TM-86H chipper
Hours:
620
Lot Size:
12 acres, 12 degree average slope, 20-30 degree typical working slopes, 45 degree max.

Statistics


Total Posts
Total Posts
1,543
Posts Per Day
0.38
General Information
Last Activity
Yesterday 07:15 PM
Join Date
03-27-2007
Referrals
0
© 2018 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.