RandyT's latest activity

  • R
    RandyT replied to the thread Trailer hubs shedding grease caps.
    From the Dexter parts catalog they claim the cotter key wasn't used after 2002, but I have them on my 2011 Sure-Trac. So either...
  • R
    RandyT reacted to dj1701's post in the thread Trailer hubs shedding grease caps with Good Post Good Post.
    I agree with WinterDeere. "DIY mods or hacks of a well-engineered system are rarely if ever an improvement" I don't own a trailer, so I...
  • R
    RandyT replied to the thread Trailer hubs shedding grease caps.
    The EZ Lubes on my Sure-Trac with Dexter axles use an offset drilled cotter pin. So the grease goes through the center but the cotter...
  • R
    RandyT reacted to flyerdan's post in the thread Trailer hubs shedding grease caps with Good Post Good Post.
    Empirical evidence indicates that this is a problem with the hub itself. Maybe there is a hairline crack in the outer bore that allows...
  • R
    Will not mow 5 ft tall weeds very well, and even with the suspension will still kill your back after riding over that bumpy ground...
  • R
    RandyT replied to the thread Scag died.
    Maybe a long shot but has anybody checked the flywheel key to see if it got sheared. Which would recreate everything to run but at the...
  • R
    RandyT replied to the thread Surging.
    No adjustment on those carbs. But if the OP replaced all those parts sounds like Chinese knockoff parts which those carbs can be hit...
  • R
    RandyT reacted to Richard001's post in the thread Surging with Good Post Good Post.
    Can you give us the engine make, model and part number ? Then maybe we can help. And yes, you are on a wild goose chase looking into...
  • R
    RandyT replied to the thread Trailer hubs shedding grease caps.
    Are we talking about the metal caps coming out or just the rubber dust covers that are used on greaseable axle trailers. I suspect that...
  • R
    RandyT reacted to fatjay's post in the thread JD 455 stalls when brake released with Good Post Good Post.
    My father had a tractor that had 2 safety's, one in brake and one in seat. If he released the brake while not in the seat, it died. He...
  • R
    My OEM original battery in my DK45S would turn on the dash light go through pre-heat and loose everything when the starter was hit...
  • R
    I would go ahead and remove the battery terminals and clean them and the post. Could still be an intermittent connection that has now...
  • R
    A poor battery connection can also cause it. The load created by the starter cause a voltage drop that caused the starter solenoid to...
  • R
    RandyT reacted to jyoutz's post in the thread Dixie Chopper with Generac Engine with Good Post Good Post.
    A replacement engine is still cheaper than a new box store ZT mower. If the rest of the machine is in good condition, I would go the new...
  • R
    RandyT replied to the thread I hate to see this....
    You only make one mistake with those chippers Your first and last are both the same.
Top