Recent content by Scojen7

PumpGuySC "crank the engine until fuel SQUIRTS OUT" Ok I did that and yes the tubes did "pulse out fuel" Not squirt as offered. Then I warmed up the glow plugs turned to crank it and still nothing fires. I even removed the air filter and tried with starter fluid still nothing. So which way do I...

Ok I will give that a shot in the am. After I get some metric flare nut wrenches. S.A.E. works but not always. Thanks again!

Ok PumpGuySC, Ok I guess getting wet shows nothing I will remove the lines and the injectors and are free of obstruction. then crank to check for flow.

Well, there are no shut-off valves in this system I did crack each injector individually and cranked until showing wet.

After a routine maintenance check I decide to change the fuel filter. after changing the filter I run the bleed procedure on the manual seeing little or no air involved. The engine cranks but does not fire up. Tried starter fluid motor bumps but nothing fires. Perplexed I start cracking the...

If I loosen each injector nozzle and crank it should leak right how much deeper do you have to check the injector's output.

I checked on the OP manual and looked at 5-25 and 5-26 followed the instructions no change

Yes it did go away might be a voltage low indication, Still nothing on the start up the fuel system needs to track this down Illustrations ?

Hey I am glad you responded. The new battery cable works it cranks well but I bled the screw and it will not fire up. Now that fuel line is clear from the junction where it splits off ok tried starter fluid still nothing. ??? Um I did this standing beside the tractor not in the seat if the seat...

Hi Tom, Long time no see, I replaced the positive battery cable it was defective on the battery end. Now I am getting a Code on the LED panel showing a "J-1" indication on the screen. What does that mean? As usual, any help is appreciated. Scott

Maybe maybe not I will try that tomorrow, Monday. My arms were not long enough thanks!

Hello Tom, Yes I am still fighting with this on the engine this time. I changed the fuel filter, it was nasty, I let the filter fill and checked the bleed for fuel pretty much air-free. Tried to start and nothing used diesel starter fluid would fire momentarily. I guess I need to look at the...

Tom, Thanks again I have a besko loader valve 801z1-8000 too. I checked the connectors blue and red a bit cruddy but clean up and reconnects ok. The boot and linkage are again cruddy but working ok. Still nothing no dump yet. I will research the valve before tearing it down. Research is sketchy...

Thanks, checking the hoses and boot.