Recent content by stray

Hi guys it has been a while since I have done a project on my power trac and posted it on here. Recently I bought a mini skid steer trencher and made an adaptor plate. But this is not why I am reporting now. I have a need and many of you after having a PT for a long while may have the same...

It looks like I shook my mini hoe muck bucket a little too hard one time to many

Dosn't anyone have a project going? Seem like there is more take about the PT than what it does.

I now have over 1000 hrs on my 2003 PT422 Robin. The only 2 problems were a fried voltage regulator and a bad coil. O yes I had to weld and brace the pivot, rollover, lift bar but that was easy. Replaced the battery and tightened a few fittings. I am well satisified with the tractor and...

I started working on this set up before but at the time I didn稚 have much use for it. I recently have had a couple of jobs where I could have used more pulling power. Just a bit more torque would have made the difference. I know this set up will be controversial and could cause damage to...

No not that cat tail

1. Build one large red bucket. 2. Pick out a worthy Job to be done. 3, Get you Dad or someone to do the hard work so you can drive the PT. 4. Now Fill that red bucket with all of the rocks the PT can ever hope to carry 5, Oh Yes! Be Sure to Have your wheels swapped to the wide...

Ok guys I haven't heard any energy around an Electric PT. I wonder if Power-trac ever considered it or will in the future. With the way things are now Conversion thoughts have ran through my mind. $15 versus 2 or 3 to mow the yard. Start first time ever time. Less noise. Conversion...

Guys. I had a failure. Help needed and appreciated!! What is this and what does it do?

Started work on the two speed modification so thought a new tread would be appropriate. There is not a lot of room here to install 8 outlets from the tram pump. In fact there is not an over abundance of room anywhere in the engine compartment.

Has anyone ever heard what sound like a brake squealing while under way in their PT. It doesn't do in all the time. I fear it may be a wheel motor. Any Ideas or experiences?

I am starting to build a side mower. I believe this will be the hardest project I have taken on yet. It will most likely be 2 or 3 weeks before finishing. I will post more pics as progress permits but for now does anyone recognize this deck?

I lifted about 2 tons of moss out of my ponds last night. at the end of the session i kept hearing a swaking sound. This morning as i was greasing the center toggle and i saw grease coming out of a farily long crack in the center. Here the proble lay. I hooked up the buzz box and welded...

As to the best of my knowledge and investigation the only time that hydraulic oil passes through the oil cooler is when the tram motors are running. If someone knows different please let us know how it does or even could. It may be that some of the PTs are set up different but my is a 2003...

I am building a ripper out of an old plow beam. I thought you all might want to see some pics. As they say a pic is worth 1000 words. This is of how I built the plate.