Recent content by sundug

Here's what I did for hinges, just welded the tines to a short length of pipe that slid over the main pipe mount.

Here's a short video on the grapple I just built, nearly all from the scrap metal pile. Scrapple? The tines are made from worn down scraper blades, the cylinder is a top link cylinder I was not using. I only had to buy $5 worth of fittings to get this project working. Doug Grapple

My 2007 Mahindra 6500 4WD has 340 hours and I was just out bush hogging with it holding the throttle against the governor at 2500 RPM when I looked down to see the oil light on! I immediately lowered the RPM, and the light went off. Slowed down to 2K RPM and the light stayed off. Went directly...

Hi, I am trying to get the steering ball end at the left hand side of the steering cylinder on my 2007 Mahindra 6500 4WD to take grease. I have removed the fitting and discovered that there is nowhere for the grease to go, the hole does not go to the ball. I have tried two different commercial...

I had most of what I needed laying around, and I am having an ever increasing hard time hand digging in my clay/chert soil, so I built what I call a front hoe. If you are interested here's some fotos of my newly built, low cost digging tool. Doug...

I have a 2007 6500 4WD. I bought it a year ago with 325 hours on it. I used to see the manifold heater light come on when I first turned on the key, now it does not, and when temps are in the 20's, it has to crank a lot to start. I found the manifold heater and light on the wiring diagram, and I...