Recent content by tmthunder

OK thanks!! it feels like it might still be attached in the corners only.

This is on the lower right hand side below the 3pt lift lever. Any idea how to get it out? I tried lightly prying from all sides but is doesn't feel like it just pops out?? Want to open it to see if the piece of my 3pt raise/lower stop is in there. I found the screw on the floor hoping the...

Thanks I will have to pull the roof off when the weather warms up and check them out. Appreciate the info!

Any one have any insight on the rear defrost not working?

Good evening, I noticed today that the rear defrost in my NX is not working. Hit the switch the red light does not come on. I checked the 20amp main fuse and the 5 amp defrost timer fuse. Both are good. Any thoughts on where to look next? Connections at the window are on and tight. I...

Hello, Does anyone have the MIE quick attach set up on their backhoe? I am looking at one for my KB2485 but wanted some real world input positive and/or negative. Does it reduce the curling force of the bucket? Looks like it would make swapping between the ripper tooth and buckets much...

Does anyone know who builds the HST's for NX series Kioti's? Are they manufactured in-house? Thanks in advance!

Here is the one I am working on for my KB2485. I have to fab up the mount when I get home again.

Good to see fellow Groomers here! I run a BR275 in the winter. Our club has 2 275's, one BR250, and just picked up a BR350 this fall(looking forward to running this one). All with Mogul Master 10' x 18' drags. They are fun to run and for me I enjoy working on them as well. Stay safe out there!

22' IronBull 14,000lb. Any shorter than 20' would have made balancing a touch harder with the backhoe attached. It was delivered on an 18' but they had the hoe swung off to the side so it would not hang off the back. I agree with the others though if you can get a bit longer you will be...

Hello All, I am working on a government project at work. Ripper tooth for my new KB2485. Unfortunately I am 600+ miles away from my tractor. In hopes that one of you may have the info I am looking for.... I found this design in a search but I do not believe it was designed for the 2485...

I have another question for the group. I am looking into purchasing a trailer to haul my new tractor with as it is not going to fit in my 14' dump. So I am looking at the Iron Bull 7 x 16 +4'(I believe but maybe 6') split tilt deck. Since I am not able to measure my tractor I was hoping...

Hello all, Has anyone found a good seat cover that fits the NX cab model seats? My new NX4510, KL6010, KB2485 w/thumb should be delivered this coming week!!! I also bought a WoodMaxx SB72 3pt snowblower with hydraulic chute and rotate. I am excited to get some seat time!

Hello, It has been a while since I have been involved with the forum. I am looking at purchasing a NX4510 HST cab unit. Trying to figure out what the better promotion is at the moment.... The free loader program or the rebate of $4300?? I have not been able to find the MSRP or selling price...

Hello, It has been a while since I have been involved with the forum. I am looking at purchasing a NX4510 HST cab unit. Trying to figure out what the better promotion is at the moment.... The free loader program or the rebate of $4300?? I have not been able to find the MSRP or selling price...