greetings
I looked in the tranny of my recently acquired MT
wow.
I am SURE I need gear/shaft part #1 and seal #2 on Fig 5-3 (input shaft)
and
Gear #30 and locknut/tabbed washer #35 and #36 on Fig 5-3
no wonder it was so cheap, lol :laughing:
Valley Power does not have a used input shaft gear, 4 weeks and 300+USD to get.
OUCH!
they have everything else, though.
Any ideas on the gear source?
thanks,
stuporman
I looked in the tranny of my recently acquired MT
wow.
I am SURE I need gear/shaft part #1 and seal #2 on Fig 5-3 (input shaft)
and
Gear #30 and locknut/tabbed washer #35 and #36 on Fig 5-3
no wonder it was so cheap, lol :laughing:
Valley Power does not have a used input shaft gear, 4 weeks and 300+USD to get.
OUCH!
they have everything else, though.
Any ideas on the gear source?
thanks,
stuporman
Last edited: