travis martinek
New member
- Joined
- May 18, 2011
- Messages
- 7
- Tractor
- mitsubishi 2201fwd
ok lets see them pictures of your tractor!
- Thread starter travis martinek
- Start date
magicheater
Veteran Member
I like the way your BH mounts high. Gives you clearance when using the loader. How deep does it dig? My guess would be 6.5'
LBrown59
Super Star Member
- Joined
- Oct 27, 2004
- Messages
- 16,851
- Tractor
- 2003 Kubota BX1500/2004 Kubota Bx23/2005 Kubota BX1500
Did you know there already was a thread about this same subject on TBN.?
OP
travis martinek
New member
- Joined
- May 18, 2011
- Messages
- 7
- Tractor
- mitsubishi 2201fwd
ya 6.5 good little digger
and to the lbrown no i did not know of one i just signed up to this site
did you want me to delete this post?
OP
travis martinek
New member
- Joined
- May 18, 2011
- Messages
- 7
- Tractor
- mitsubishi 2201fwd
Attachments
8NLUGNUT
Silver Member
- Joined
- Dec 6, 2007
- Messages
- 205
- Location
- Central Texas
- Tractor
- Several Fords, four Japanese tractors
Here's a Beaver III I bought at the junk yard.
It looks really rough, didn't run and I paid more than I should've.
But I like it.
I found a few air leaks in the fuel system.
Put a used battery on it.
Replaced a freeze plug and a new radiator cap.
Three tubes, crossed my fingers and fired it up.
It runs good, the clutch is strong and it drives around in first. Only.
Once I get a look at the gear boxes I'll be consulting the Tractorbynet.com gurus as to what the loud grinding/rattling is in the back end.
The PTO works but the lift doesn't come up and the shifter won't put it into any other gears.
Here's a picture and a link to it running.
YouTube - MrBubbasBulletman's Channel
It looks really rough, didn't run and I paid more than I should've.
But I like it.
I found a few air leaks in the fuel system.
Put a used battery on it.
Replaced a freeze plug and a new radiator cap.
Three tubes, crossed my fingers and fired it up.
It runs good, the clutch is strong and it drives around in first. Only.
Once I get a look at the gear boxes I'll be consulting the Tractorbynet.com gurus as to what the loud grinding/rattling is in the back end.
The PTO works but the lift doesn't come up and the shifter won't put it into any other gears.
Here's a picture and a link to it running.
YouTube - MrBubbasBulletman's Channel
Attachments
Satoh Buck.. Just bought it last Thursday.!
Attachments
Kuenzli
New member
I think this is just like the one I bought used. I need a hydraulic oil filter, any idea about where I can find one? I've been looking online without any success. If you can point me in the right direction, to a dealer or to a site, I'd appreciate it. I put a post in the hydraulics section of this site in hopes to reach out to someone who might know where I can get one. If you can help me out with the info, I'd appreciate if you could post it there. Thanks! H. Kuenzli
oliver28472
Veteran Member
The filter on these is a fine mesh tube screen that you remove, clean and put it back in. It is located on the right side at the bottom of the rear case. I think it has two bolts holding it in. The only time you'd need a replacement is if the screen has a hole in it.