Results 1 to 2 of 2
01-07-2013, 12:18 PM #1
MTD Model 141- move universal joint to replace drive belts to PTO ?
I have to replace the drive belts to the power take off. The drive shaft goes thru them .
Therefor I must slide a universal joint back on the drive shaft and off the motor. I am a little afraid of trying.
The Penney manual states "16HP, model 1853, Catalog No. 811-0801"
It is MTD Model 141-990A.
I have a note that it was manufactured in 1981.
Thanks for your help,
01-10-2013, 08:33 AM #2
Re: MTD Model 990- move universal joint to replace drive belts to PTO ?
Sorry, I've learned it is a Model 990
By jpaeye in forum Owning/OperatingReplies: 9Last Post: 10-27-2012, 12:03 AM
By onyx6154 in forum Parts/RepairsReplies: 0Last Post: 05-24-2011, 11:18 AM
By Riddler in forum Cub Cadet L&GReplies: 7Last Post: 04-06-2011, 10:47 AM
By Cord in forum Build-It YourselfReplies: 24Last Post: 10-13-2005, 06:48 AM
By cchoate in forum AttachmentsReplies: 7Last Post: 08-24-2005, 12:51 PM