Results 1 to 3 of 3
  1. #1
    New Member
    Join Date
    Feb 2011
    Posts
    3

    Default TN75DA CODE 77

    Code: 77 Internal ECM supply voltage (8V) is too high.
    Condition: ECM detects that the voltage at ECM connector 2, pin35 is above 8 volts.
    Code causes: Faulty ECM. ECM connector 2, pin 35 is/was shorted by an external 12 volt source. Internal circuit short to 12 volts.
    NOTE: Connector 2, pin 35 is not used externally as an actual output. There is no wire coming in/out of pin 35. I checked the voltage on the pin. It is at 7.96 volts.
    Effects: Transmission is critically disabled. Will not move.
    Has anyone seen this problem/code before? Is the controller the only problem or did something else cause the failure? If I install a new controller will the same problem occur and burn up a new controller? Im leaning towards controller because of the code. Other component failures SHOULD throw another code. Any help would be great. Thanks alot.

  2. #2
    Super Member RickB's Avatar
    Join Date
    Sep 2000
    Posts
    7,038
    Location
    Eastern NY
    Tractor
    Case 885, JD 730D, Ford 4000

    Default Re: TN75DA CODE 77

    Please do not double post.
    We have too much gun control.
    What we need is more idiot control.

  3. #3
    Platinum Member
    Join Date
    Dec 2005
    Posts
    636
    Location
    Central Maine

    Default Re: TN75DA CODE 77

    Sounds like you will need to contact the nearest dealer service department. It actually sounds like a faulty contact.

Similar Threads

  1. Residential Code Question ???
    By EddieWalker in forum Related Topics
    Replies: 40
    Last Post: 11-30-2009, 11:34 AM
  2. Honda 4 wheel service question
    By Mark_in_NH in forum ATVs & Utility Vehicles
    Replies: 16
    Last Post: 09-17-2009, 08:25 PM
  3. bobcat t250 error code
    By grapple man in forum Bobcat Construction Equipment
    Replies: 1
    Last Post: 05-26-2009, 10:10 PM
  4. TN75DA Error Code 47?
    By ezslim in forum New Holland Owning/Operating
    Replies: 2
    Last Post: 09-24-2008, 07:33 PM
  5. TN shuttle trouble code
    By Rowski in forum New Holland Owning/Operating
    Replies: 6
    Last Post: 07-18-2006, 01:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2013 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.