ford 4610

   / ford 4610 #1  

tractorboy3011

New member
Joined
Mar 12, 2014
Messages
14
Hi my ford 4610 has trouble starting off in gears higher than low one i adjusted the biting point on the clutch but it didnt do anything any ideas?

ForumRunner_20140404_203724.png
 
   / ford 4610 #2  
Can you be more specific with describing your problem? Does the engine die, does the tractor shudder..... I flunked Mind Reading 101-ask my wife!
 
   / ford 4610
  • Thread Starter
#3  
Well the engine stays running but goin on flat ground it takes a lot of revs to get rolling as if the handbrake was on(but i know its not stuck on)
 
   / ford 4610 #4  
What rpm are you starting out with? Is the clutch slipping? Do you smell anything like a burned clutch? Any sign of oil dripping from the bell housing? How do you know the brakes are not stuck?
 
   / ford 4610
  • Thread Starter
#5  
Idleing rpm but to get moving needs high rpm.no smell or oil.i know the brakes arent stuck on as it acts normal in lowest gear.
 
   / ford 4610 #6  
What are you talking about regarding "...high rpm to get moving..."? Idle is about 700-800 rpm So what does it take to get you moving? max rpm is ~ 2200rpm so you have between say 800 to 2200 rmp working range.
 
   / ford 4610 #7  
What transmission do you have? Shuttle or standard 8x2? Sent from my iPhone using TractorByNet
 
Last edited:
   / ford 4610
  • Thread Starter
#8  
Standard but its 4 gears a range(hi,lo,reverse)
 
   / ford 4610 #9  
Standard but its 4 gears a range(hi,lo,reverse)
8 forward and 2 reverse total correct? Also do all gears other than 1st slip or is it just certain gears?


Sent from my iPhone using TractorByNet
 
   / ford 4610
  • Thread Starter
#10  
8 forward four reverse and it only starts moving right in lowest gear.could it be the clutch?
 
 
Top