dvanhorn81
New member
I am new to this forum. I have a question about replacing a dual stage clutch in a 1630 with a 9 x 3 transmission. First time doing this work.
I purchased the repair manual, and have torn down the tractor and split the unit to access the clutch. It says in the book to adjust the clutch finger height. I have spoken to the dealership, and ask them about the setting guage. They said to just look up the measurement and adjust with out the tool. Does anyone know what the height should be??
Can't seem to locate the dimension from the flywheel to the adjusting bolt. Any help would be appreciated/
I purchased the repair manual, and have torn down the tractor and split the unit to access the clutch. It says in the book to adjust the clutch finger height. I have spoken to the dealership, and ask them about the setting guage. They said to just look up the measurement and adjust with out the tool. Does anyone know what the height should be??
Can't seem to locate the dimension from the flywheel to the adjusting bolt. Any help would be appreciated/