Stump Jumper

[Bird Dog]

I've purchased a 6' Rotary Mower. Replaced Bearings and oil seals in gear box. Once I had the Stump Jumper off the unit I noticed the stump jumper was not flat on the bottom. Were the blades bolt on the steel brace going across the stump jumper its flat, but has some contour bending upperward towards the mowing deck along each side of the steel brace that the blades attach and gear shaft goes through. Apparently the previous owner ran over something. Concern if I reassemble I may have vibration, Im not sure. Questions I have will I have vibration if the stump jumper is not flat? I've tried to strighten it but so far I havent had any sucess.

Thanks,

Bird Dog

 

[Muhammad]

Hello Bird Dog, welcome to TBN! Glad to see you posting. Hope you enjoy being a member of our community.

 

[Bird Dog]

Thanks, I'm looking forward to using this site.

Bird Dog

 

[yooper1]

Hello and welcome to TBN

You may want to ask your question about the mower / stump jumper in the attachments area here

Attachments - TractorByNet.com

More people will see it and hopefully be able to offer ideas / advice

 

[Bird Dog]

Thanks for the info.

 

[CompactTractorFan]

Welcome to TBN!!!

 

[Code54]

Welcome to the forum!
I am looking at rebuilding a brush hog myself so I am interested in what you learn