Need A Premo Mug, Cup, Or Water Bottle Holder?

[PineRidge]

I drink a LOT of coffee and ice water. Unfortunately the cup holder on my New Holland likes to dump my drink before I get a chance to even reach for it. Here is an inexpensive remedy for that problem that I am sure you will all appreciate. /forums/images/graemlins/grin.gif Click here for pictures

 

[jinman]

Nice job! that's sure an improvement on the "top-of-the-toolbox" model. I've been planning on how I can better utilize the area behind my seat. I'm thinking bigger toolbox and cupholders in that area too. Where you put yours, I normally have a stack of tow-chain, but I need to find a better place for my chain. One time I had small chain there and it dropped down through the opening. If the end had managed to get under the rear tire, there is no telling what I would have destroyed. /forums/images/graemlins/blush.gif

 

[KrisHansen]

Now that is sweet!!! I have been thinking of crafting some sort of cupholder too, I love your design!!

 

[PineRidge]

Jim I have also just finished up mounting a large toolbox just behind the seat. It is supported by the ROPS, without modification to it an any way. And it is made of the same material and of the same color as the fuel tank on the New Holland tractors. I think you'll like it, I will be posting pictures of it at TBN very shortly. /forums/images/graemlins/smile.gif

 

[Bob_Skurka]

OK guys I haven't mounted a cup holder (YET) but I did put a nice tool box on the back of my TC24D. I used a black diamondplate truck box for the toolbox and mounted it to a piece of 1/8" plate that I bent to fit behind the seat, without modifying the tractor in any way.

Here is a link.

Boomer Custom Toolbox Thread

 

[WannaNH]

I just added a cupholder to my TC30 using this basic design. I was able to find a black ABS 3" cap that was already flat on the bottom. Used white PVC pipe and it matches the color scheme. May paint it, or may just leave it.

Randy

 

[erosol]

do you have pics of you holder. I would love to have one on my tractor that works good.

 

[WannaNH]

Here's mine. I used a 2" long 3/8" carriage bolt, but could've gotten away with 1.5". I placed a flat washer between the fender and cup holder for drainage. I need to put another flat washer under the fender.

It holds a 20 ounce bottle of gatorade, a 500 ml soda bottle and a 12 ounce beer bottle in one of the zippered neoprene koozies.

It will not hold a 12 ounce can in a foam koozie. Might need to use 4" PVC and make it shorter. I may experiment with that. I have another fender with an identical hole to the left! Never know what kind of beverages i have in the fridge, so I need to have cup holders for a variety.

Wonder if there's some way to make them quick detachable?

 

[kozak]

Nice slick designs both of them. I like the idea of not having to drill any holes.....but then the fender design would be more convenient.

Hmmmmm,

Vic

 

[WannaNH]

I used a pre-existing hole in the fender. Not sure what it's for, but it's situated perfectly for a cupholder.