Anonymous Poster
New member
- Joined
- Sep 27, 2005
- Messages
- 0
I would like to to protect the factory-new edge of my FEL bucket. A toothbar has been strongly recommended, and I intend to get one. But initially, I'll be using the FEL for relatively light landscaping and garden work, so I'm wondering if something less aggressive might be in order. And while the cost of a toothbar is not huge, a less expensive alternative wouldn't be a bad idea, given the recent outlay for the tractor etc.
So- /forums/images/graemlins/confused.gif
How much should I expect to pay for a straight cutting edge?
Where would be the best source for one?
Can this be a bolt on addition, allowing it to be removed and swapped for a toothbar?
Am I completely off base?
I'll take delivery in about a week and a half, so I may have an oportunity to take care of this before I even scratch the paint /forums/images/graemlins/shocked.gif but I would rather wait and do it right than jump in and get it wrong.
So- /forums/images/graemlins/confused.gif
How much should I expect to pay for a straight cutting edge?
Where would be the best source for one?
Can this be a bolt on addition, allowing it to be removed and swapped for a toothbar?
Am I completely off base?
I'll take delivery in about a week and a half, so I may have an oportunity to take care of this before I even scratch the paint /forums/images/graemlins/shocked.gif but I would rather wait and do it right than jump in and get it wrong.