horsefarm84
New member
Hello,
I'm a new Kubota BX2200 tractor owner and I have very little knowledge of hydralics. Mt BX2200 has a 4-way valve joystick-type hydralic countroller mounted on the driver's right side. I have a BX2711 front-mounted quick hitch which has (2) hydro hoses to adjust the up/down pump and a BX2763 snowblade which has (2) hoses to adjust the blade's angle of attack pnmp. All the hoses are connected but their movement is very minimal; both only have about 1/4" to 1/2" of travel. Basically, the blade is currently at a straight 90 degree angle of the tractor and is positioned about 6" off the ground. I can't adjust the blade at a slanted angle or lower it closer to the ground. Any ideas what may be occuring or what I may have done wrong?...
I posted this issue in a different thread but it was buried under a couple pages of dialogue so I figured I'd repost in a new thread.
Thanks for any thoughts or guidance.:confused3:
I'm a new Kubota BX2200 tractor owner and I have very little knowledge of hydralics. Mt BX2200 has a 4-way valve joystick-type hydralic countroller mounted on the driver's right side. I have a BX2711 front-mounted quick hitch which has (2) hydro hoses to adjust the up/down pump and a BX2763 snowblade which has (2) hoses to adjust the blade's angle of attack pnmp. All the hoses are connected but their movement is very minimal; both only have about 1/4" to 1/2" of travel. Basically, the blade is currently at a straight 90 degree angle of the tractor and is positioned about 6" off the ground. I can't adjust the blade at a slanted angle or lower it closer to the ground. Any ideas what may be occuring or what I may have done wrong?...
I posted this issue in a different thread but it was buried under a couple pages of dialogue so I figured I'd repost in a new thread.
Thanks for any thoughts or guidance.:confused3: