Results 1 to 2 of 2
01-06-2013, 04:47 AM #1
- Join Date
- Mar 2009
How can I attach a hydraulic Top Link to Iseki TX 2160 HST?
My Iseki has two hydraulic connections at the rear (Lets call them Connector 1 on the left and Connector 2 on the right)- At least that's all I can see.
I have a rear forklift with a single acting Hydraulic Ram onto the 3-pt hitch of my Tractor. I can use the 3-pt hitch lever to lift the whole unit up/down, and the tipper control handle (left of, and under the seat) to raise and lower the forks through a single pipe into Connector 2..
I now wish to replace the fixed Top Link with a hydraulic one. This is basically a double action ram. I don't have any remaining services that I can see, although Connector 1 is still not being used.
Can anyone advise how I might do this? Apologies if I have not provided enough info, and thanks in advance.
01-08-2013, 07:26 PM #2
- Join Date
- Nov 2005
- Southwestern, PA
- 1958 Ford 961 Powermaster
Re: How can I attach a hydraulic Top Link to Iseki TX 2160 HST?
Do you have any pictures? I have two rear remotes on my tractor and each remote has two places to attach hydraulic lines.Kubota L5240 with loader and backhoe
1958 Ford 961 Powermaster LP
3-Point Hitch Top link ball socketsfor Iseki tractorBy chupacabra in forum IsekiReplies: 2Last Post: 05-27-2012, 04:09 PM
By Donfi in forum Kioti Owning/OperatingReplies: 6Last Post: 10-01-2011, 12:18 AM
By Ron D. in forum Kubota Owning/OperatingReplies: 3Last Post: 07-22-2009, 06:55 PM
By Dougd in forum Parts/RepairsReplies: 1Last Post: 01-28-2008, 09:39 PM
By Bob_Young in forum Owning/OperatingReplies: 19Last Post: 01-11-2006, 12:47 AM