CalG
Super Member
- Joined
- Sep 29, 2011
- Messages
- 5,094
- Location
- vermont
- Tractor
- Hurlimann 435, Fordson E27n, Bolens HT-23, Kubota B7200
I crawled under the Hurlimann this morning to adjust the cable operated clutch. There was just too much free motion in the pedal to my liking.
While looking up, I noticed a lax lock washer under the head of one of the loader mounting frame members. Sure enough, Finger tight.
A check of all eight of the similar frame bolts (far side and near) no less than 6 fasteners needed "significant" snugging up.
18 mm box end and a bit of elbow grease and it's all good. A tuff spot to r&r for lock tight.
Don't let those snaps creaks and groans go unheaded!
While looking up, I noticed a lax lock washer under the head of one of the loader mounting frame members. Sure enough, Finger tight.
A check of all eight of the similar frame bolts (far side and near) no less than 6 fasteners needed "significant" snugging up.
18 mm box end and a bit of elbow grease and it's all good. A tuff spot to r&r for lock tight.
Don't let those snaps creaks and groans go unheaded!