woodlandfarms
Super Member
- Joined
- Jul 31, 2006
- Messages
- 6,118
- Location
- Los Angeles / SW Washington
- Tractor
- PowerTrac 1850, Kubota RTV x900
OK, I am getting desperate.
A bolt on my mower broke off rather low in the hole. I have been able to work it up to the surface but now it is completely jammed.
I have lubed it, waxed it, hit it with a torch, Tried to use an extractor, and have been using the old school method of hammer and punch and working it around.
I am concerned that all I have left is welding a bolt on and I am not much of a welder and this is quite flush.
Looking for ideas I have not thought of.
The bolt is 5/8" btw..
Carl
A bolt on my mower broke off rather low in the hole. I have been able to work it up to the surface but now it is completely jammed.
I have lubed it, waxed it, hit it with a torch, Tried to use an extractor, and have been using the old school method of hammer and punch and working it around.
I am concerned that all I have left is welding a bolt on and I am not much of a welder and this is quite flush.
Looking for ideas I have not thought of.
The bolt is 5/8" btw..
Carl