ryanbr
Bronze Member
- Joined
- Jan 24, 2008
- Messages
- 53
- Tractor
- White 2-105, Cockshutt 770
Recently noticed the drawbar support on my tractor had a couple of bolts broken off inside the rear housing. I can not get in there to weld on to them so a extractor is my only option. its a 3/4" bolt so it should be fairly easy to work at, the problem is that its not a clean break, its all jagged and rough which will make it hard to find the center of the bolt. As per the recommendations of my local tool shop I bought something like this http://www.drillspot.com/pimages/75/7514_300.jpg (not the set, just the size i needed which is a bout 3/8 i think), the one bit cost $32!!
Anyone have any tips or suggestions for this kind of thing?
Anyone have any tips or suggestions for this kind of thing?