moojamboo
Bronze Member
I ordered the repacking kit for my Ford 770A loader bucket cylinder. i managed to get the cylinder off the tractor. I was following the instructions i have in the loader manual but I'm having difficulty moving the cylinder shaft.
This is what the cylinder looks like now.
I can't seem to push or pull the cylinder at all. I was able to rotate the cylinder shaft with a metal bar through pin hole in the top end of the cylinder tube with a clamp holding the tube while i rotated the shaft. i tried moving the shaft in by using a small sledge hammer and a block of wood and nothing seemed to move.
Any advice welcome as you can see here the second step in the instructions says to push the shaft in all the way.
I have read that others have done this job in little time and my local dealer told me it would be a morning project. i have spend 2 hours trying to figure out how to move the cylinder please help.
This is what the cylinder looks like now.
I can't seem to push or pull the cylinder at all. I was able to rotate the cylinder shaft with a metal bar through pin hole in the top end of the cylinder tube with a clamp holding the tube while i rotated the shaft. i tried moving the shaft in by using a small sledge hammer and a block of wood and nothing seemed to move.
Any advice welcome as you can see here the second step in the instructions says to push the shaft in all the way.
I have read that others have done this job in little time and my local dealer told me it would be a morning project. i have spend 2 hours trying to figure out how to move the cylinder please help.