I broke a u joint in my tiller shaft, I think the shaft is a bit long because it seemed to bind if I raise the tiller full up while engaged.
Has anyone ever shortened a tiller shaft by cutting/rewelding?
How critical is the balance on these shafts?
I'm also considering converting the yoke to a size I can buy locally since I cant find this size u joint?
Any advice is appreciated
Has anyone ever shortened a tiller shaft by cutting/rewelding?
How critical is the balance on these shafts?
I'm also considering converting the yoke to a size I can buy locally since I cant find this size u joint?
Any advice is appreciated