Please help me as I'm at a lost end. I had to take my transmision apart to replace some gears and now holy cow, when I removed the Grown gear I had to remove caps with 6 bolts on each, behind caps were shims, I looked at them and they looked the same but I did not pay more attention to them.
Now that I am putting everything back I figure shims are not in right place because when I attach the drives the whole thing tightens up that you can hardly turn the xls. My question is how do I tune the grown gear, how do I measure the gap in the teeth, seems it needs to be shimed properly. All is good till I attach the drives and tighten them.
THANKS FOR ANY HELP
LOU
Now that I am putting everything back I figure shims are not in right place because when I attach the drives the whole thing tightens up that you can hardly turn the xls. My question is how do I tune the grown gear, how do I measure the gap in the teeth, seems it needs to be shimed properly. All is good till I attach the drives and tighten them.
THANKS FOR ANY HELP
LOU