Results 1 to 3 of 3
  1. #1
    New Member
    Join Date
    Feb 2012
    Posts
    3
    Location
    Fort Benton
    Tractor
    mitsubishi mt3201fd

    Default mitsubishi driveshaft

    I am about to seperate my mitsubishi mt3201fd tractor to work on the clutch. Can anybody tell me how to remove the drive shaft.

  2. #2
    Veteran Member Kernopelli's Avatar
    Join Date
    Oct 2006
    Posts
    1,758
    Location
    Carterville, Illinois
    Tractor
    Mitsubishi MTE2000D, Dig It 258 Backhoe

    Default Re: mitsubishi driveshaft

    The sub 30HP Mitsubishis usually have a tube or shield on each end of the driveshaft. That has to be removed and the shaft slides onto the yoke of a splined ujoint and held in place with a pin that goes through the center of the shaft/yoke and is held in place by a metal clip. Probably a similar setup on the 3201
    Darryl

  3. #3
    New Member
    Join Date
    Feb 2012
    Posts
    3
    Location
    Fort Benton
    Tractor
    mitsubishi mt3201fd

    Default Re: mitsubishi driveshaft

    Thanks Darryl once I got the shield off it was clear how things came apart.

Similar Threads

  1. Mitsubishi/Satoh vendor list and general info
    By ekrampitzjr in forum Mitsubishi/Satoh
    Replies: 12
    Last Post: 06-01-2010, 08:29 PM
  2. Is there yet a 2-piece driveshaft for 2210?
    By JDLou in forum John Deere Owning/Operating
    Replies: 6
    Last Post: 09-20-2009, 05:52 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2014 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.