Results 1 to 3 of 3
-
05-14-2003, 10:40 AM #1
- Join Date
- Apr 2003
- Posts
- 116
- Location
- southern states
- Tractor
- Hinomoto e2004 aka 5020
pto driveshaft wobble allowable?
I was wonder how much wobble is there allowed for a 2' tiller pto shaft? I had to weld one end and now it appears to be wobbling a little. [img]/forums/images/graemlins/blush.gif[/img]. at 540 rpm i don't see how it would hurt other than wearing out the u-joints??
thanks
-
05-14-2003, 01:07 PM #2Elite Member
- Join Date
- Mar 2002
- Posts
- 3,237
Re: pto driveshaft wobble allowable?
I believe you are allowed 5/32",+ or - 1/64" [img]/forums/images/graemlins/tongue.gif[/img].
-
06-17-2003, 11:49 PM #3New Member
- Join Date
- Sep 2005
- Posts
- 0
Re: pto driveshaft wobble allowable?
Hinomoto Mike It could also cause wear in the splines where they slip on if its real bad. You could take it to a drive line shop and they can put it in amachine and find out how much it is out of balance then they tack weld a counter weight on the otherside to correct it.
Ralph
Reply With Quote
