Justin Santander
New member
I have just got done painting my international 300 utility tractor and replaced the engine gaskets with a complete engine gasket set. Reassembled everything and went to start it and it will not fire. I have installed a new battery, new coil, new points, new cap on distributor, all new wiring, new solenoid, rebuilt starter, new plug wires, installed a carburetor tune-up kit, adjusted float to proper setting, installed new alternator, new key switch, I have double checked all the wiring to be sure it was correct according to a number of forums that I have got information off of. I have checked the timing over and over again to be sure that it was set correctly and all checks are good. Point Gap is set to .020 and spark plug gap is set to .023 via specification in Shop manual that I purchased. I have good clean blue spark to the spark plugs, getting fuel to the carburetor. cleaned and sealed inside of gas tank and replaced fuel bowl gasket and screen and also installed an inline fuel filter. Is there something I am missing that would keep my machine from actually firing. I am in dire need of this machine and need some help please. Is there anyone that could assist me with some advice about what I need to do next.
Thank You
Thank You