bjr
Veteran Member
Okay, I致e included schematic of what I think is correct. I知 hoping someone with single phase motor knowledge will concur or tell me where I知 wrong. My question is, are the two start and two run capacitors wired in series with each other. I guessing that in series they boost the voltage. The motor drives a shop compressor and was running for many years. Then quit and I found tripped circuit breaker. I致e had the capacitors tested the motor windings megger tested by a motor shop, all tested good. I致e since cleaned the stationary contacts on the centrifugal switch cleaned the flyweights. I replaced the bearings while I had it apart. I need to make this run again. I tried to remember how the original wiring was but my notes were not correct so I had to start all over to wire up the capacitors and the motor shop was pretty tight lipped about providing wiring information. Thank you. bjr