PLEASE HELP!!!!

   / PLEASE HELP!!!! #1  

TractorFiend

New member
Joined
Jul 15, 2003
Messages
2
Hi I recently purchased a Mitsubishi 1800D Tractor 2WD. When i got it, it was working fine. Eventually the lift stoped working to full potential IE. It would hardly lift my small grador Box. So i finally figured out it was the O-Rings in the pump. I replaced them and after 3 weeks they have alredy gone bad again!!! /forums/images/graemlins/confused.gif I was wondering how to fix this problem and also where to get a seal kit.

Thanks Alot,
Forrest
 
   / PLEASE HELP!!!! #2  
Is there a Crown Products in your area. I have one near me & if I carry in my old Orings & seals, they can normally match.
 
   / PLEASE HELP!!!! #3  
Dirt in the hydraulics? /forums/images/graemlins/confused.gif
 
   / PLEASE HELP!!!! #4  
I remember reading that a nick, cut, or scratch on the rod can cut the seals. Extend the rod out of the cylinder and inspect for damage.
Mark
 
   / PLEASE HELP!!!!
  • Thread Starter
#5  
thanks guys i'll check this stuff
 
   / PLEASE HELP!!!! #6  
Use the Vitom high temp. O-Rings
 
 
Top