BuckeyeWilly
Member
I retired in November so decided a good winter project would be to give the Kubota a complete overhaul. 5 years of hard work had her lookin pretty bad. All the lights on the back end where busted up so I bought a set to replace the broken ones. These are the ones that bolt onto the rops.
The new light had only one black wire so I connected the black wire from the tractor to the black wire on the light and ground the red wire to the bolt of the light and it worked fine so I bolted it to the rops and nothing. No turn signal and then the blinkers on the console even quit working. I checked the fuses and they are fine. I even change them around . Nothing!!
I have no power to any of the lights on the back. I checked the 50 amp breaker also and it seems fine. I guess my question is "is there an inline fuse going to the tail lights that I don't know about? Any ideas?
The new light had only one black wire so I connected the black wire from the tractor to the black wire on the light and ground the red wire to the bolt of the light and it worked fine so I bolted it to the rops and nothing. No turn signal and then the blinkers on the console even quit working. I checked the fuses and they are fine. I even change them around . Nothing!!
I have no power to any of the lights on the back. I checked the 50 amp breaker also and it seems fine. I guess my question is "is there an inline fuse going to the tail lights that I don't know about? Any ideas?