JoeJChin
Member
Anybody out there familiar with the following type injection pump ?
link to picture
http://www.jhdiesel.com/Mvc-017s.jpg
It's a Yanmar pump off a JD 750 compact tractor .
I was having trouble getting the tractor started , and ended up pulling the pump off of it .
I don't think the pump is working properly .
After all the normal bleeding purging etc trying to get the tractor started again ( 20 minutes after shutting it off )
I pulled the access cover off the side of the gear case , and it doesn't look like the rack is moving in the pump when i move the throttle lever back and forth .
If you look at the right hand picture , what i have seen called the rack , is the rod , with the pin sticking out of it .
The pin is what sets into the yoke of the throttle arm .
I pulled the pump out , and i can move the rod , but it moves very hard.
Kind of takes two thumbs on it to make it move .
The only reference i have seen , is that it "should move freely" .
I was wondering if anyone here has had one out and can tell me how "freely " it is supposed to move , and if there is any reason
it would get so hard to move while i was running it .
thanks
Joe
link to picture
http://www.jhdiesel.com/Mvc-017s.jpg
It's a Yanmar pump off a JD 750 compact tractor .
I was having trouble getting the tractor started , and ended up pulling the pump off of it .
I don't think the pump is working properly .
After all the normal bleeding purging etc trying to get the tractor started again ( 20 minutes after shutting it off )
I pulled the access cover off the side of the gear case , and it doesn't look like the rack is moving in the pump when i move the throttle lever back and forth .
If you look at the right hand picture , what i have seen called the rack , is the rod , with the pin sticking out of it .
The pin is what sets into the yoke of the throttle arm .
I pulled the pump out , and i can move the rod , but it moves very hard.
Kind of takes two thumbs on it to make it move .
The only reference i have seen , is that it "should move freely" .
I was wondering if anyone here has had one out and can tell me how "freely " it is supposed to move , and if there is any reason
it would get so hard to move while i was running it .
thanks
Joe