How NOT to Install Dry Cylinder Sleeves

[MasseyWV]

.

[mpham]

I wonder if the pistons will even fit in the bore? If it ever runs I bet it wont last long.

[alchemysa]

I've never had to do liners but I wonder if putting them in the freezer for a while would have made things easier.

[Baby Grand]

I've never had to do liners but I wonder if putting them in the freezer for a while would have made things easier.

... and the block in an oven set at WARM.

Or you could just smack it with a sledge hammer and a plank.
Make sure you get that liner in there all crooked before you commence to wail on it.
It's seeing things like this that makes me dread buying anything used.

[90cummins]

WOW!! So obvious it was not lined up.
Yup, chilling the liners in a freezer & heating the block with a couple heat lamps would allow them to fall in.
I agree with Baby Grand! If someone tells you they rebuilt it, or it looks like it was repaired, BEWARE.
90cummins

[gaspumpcity]

Never hammer on liner pacs! Are the pacs oversize?

[MasseyWV]

Watching the video made me cringe, with every blow of the hammer I just knew that cylinder was being bent to heII.

[Bladehauler]

Holy Crap !! I cant watch this abuse anymore ..........

I have had great luck with dry-ice . liner , sleaves .etc.

But a SLEDGEHAMMER ??????? The ONLY place for a Sledgehammer is on this IDIOTS HEAD !!!!!

[Tig]

Couldn't watch past 1:28
Probably because I'm afraid it will bring back memories of things I've witnessed or done.

[ruffdog]

I start my nails straighter than that! OMG!