Hello, I'm new to this forum so any help would be great. I just bought a 646 with a Davis D-100 backhoe. While on a job the left rear axle slid out. It appears that the end of the shaft is eaten off and will no longer hold the c clip. I am looking for an axle but they are out of production. Does anyone know where I might get one? I also have very slow travel speed. More so in forward than reverse. The hydraulics are strong both on the hoe and the loader. The previous owner said they were running 10w40 for hydraulic oil. Any info on any of my problems would help me as a new owner. Thank you
Parts for a case 646
- Thread starter toad430
- Start date
GManBart
Elite Member
- Joined
- Dec 10, 2012
- Messages
- 4,967
- Location
- Detroit, Michigan
- Tractor
- Massey Ferguson 241, Kubota SVL90-2
Welcome to TBN!
Some possible sources listed in this thread:
http://www.tractorbynet.com/forums/case-ingersoll/307632-case-646-parts.html
A thread on the same basic topic on another forum, with some possible resources:
http://www.mytractorforum.com/showthread.php?t=244495
Some possible sources listed in this thread:
http://www.tractorbynet.com/forums/case-ingersoll/307632-case-646-parts.html
A thread on the same basic topic on another forum, with some possible resources:
http://www.mytractorforum.com/showthread.php?t=244495
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,915
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
:welcome: to TractorByNet! :thumbsup:
10w40 motor oil is correct for the hydraulic system.
Have you found the Case -Ingersoll forum: http://www.tractorbynet.com/forums/case-ingersoll/
10w40 motor oil is correct for the hydraulic system.
Have you found the Case -Ingersoll forum: http://www.tractorbynet.com/forums/case-ingersoll/
I am glad to know that is the correct hydraulic fluid. I was dreading a full drain and replacement. thank you