Tc40 a left console removal

[Gfagel]

My shuttle lever snapped off a few days ago. I have a replacement
On order. Am trying to figure out how to
Remove the left console. I have the two rear bolts removed
And suspect there is another bolt but don't know where it is. Can some one help
Thanks in advance
Gary

 

[Halftrack]

Raise the hood and on the outside edge of the firewall there are two bolts that screw into the console panels. I think they are the same size as the rear bolts. When replacing, be sure all are aligned and then tighten. and welcome to TBN

 

[Gfagel]

Raise the hood and on the outside edge of the firewall there are two bolts that screw into the console panels. I think they are the same size as the rear bolts. When replacing, be sure all are aligned and then tighten. and welcome to TBN

Thank you shuttle lever arrived now all I have to do is get the hood latch to open.
Always sticks at the worst time.

 

[mikim]

Use a really long socket extension on those bolts in the firewall - makes it a bit easier....

 

[Gfagel]

Use a really long socket extension on those bolts in the firewall - makes it a bit easier....

Next issue down to removing the pin. How do you get the pin
Out to replace the shuttle arm.

 

[Halftrack]

Looks like a roll pin. You need a 5 mm drift to knock it out. Maybe a little rust solvent also.

 

[Gfagel]

Next issue down to removing the pin. How do you get the pin
Out to replace the shuttle arm.

Thank you all who guided with this repair
Some liquid wrench a few chosen words and
A few hits on a drift pin. Was able to get it back up and working
Thanks again