rops bolts came out

[Mace Canute]

I have a 1/2" drive Johnson Bar and if I go west of the Ontario/Manitoba border the same bar is called a 'strong arm'. Weird.

In the case of the OP, I think I would try a piece of redi-rod/threaded rod about 8" long with a nut on either end and just start turning the nuts to suck the holes into position where I could stuff a bolt in the hole next to the rod and get a nut on it. I would also use grade 8 bolts.

That's the ticket! :thumbsup: "Give the man a Kewpie Doll!" :laughing:

 

[Looking4new]

Thanks for the doll, Mace! I would rather have a 'attaboy' though.

 

[k0ua]

Johnson Bar is also known as a 'breaker bar', as well as a 'strong arm'.
'All thread' fits better than 'redi-rod' to me too.

Thanks, breaker bar I know..