Darrin Brown said:
I ran a diesel bobcat S205 skid steer out of fuel. Now I cannot get it restarted. Any help on how to get it started again?
As mentioned, the manual will have specific instructions on that engine. In general, here's how I'd suggest doing it.
Start with the filter(s). Fill them COMPLETELY with fuel. (Some filter assemblies have a sight glass. That helps) Go next to the PRIMARY FUEL PUMP (A.K.A. "lift pump") It will have a manual priming "arm" or lever. Break loose the fitting where the fuel leaves that pump. Stroke the manual lever a few times if needed, to get fuel flow from that loosened fitting. Re-tighten fitting when complete. (ALL the primary pumps I'm familiar with are driven off the camshaft. It may be resting on "high cam". If so, the engine will need to be bumped over slightly until the pump is at low cam, and will pump with the lever) Now find the bleed screws on the injector pump. (Some have a "lower" bleed screw and an "upper chamber bleed screw" Start with the lower one. Get a good flow of fuel through it. (May need to manually pump that lift pump again) When you have good flow there, close lower and start bleeding "upper bleed screw" until you have good flow there. Next, crack loose an injector line. (I USUALLY do the line where it leaves the injector pump, but sometimes it requires bleeding right at the injector. Crank over the engine (with starter) until you get fuel at the injector. Sometimes an engine will go ahead and start with one or 2 injectors getting fuel. Sometimes it requires ALL injectors to be bled. Once you have fuel to the injectors, start cranking the starter until she fires. If it doesn't start soon, go back through the entire proceedure again. Some diesels won't hit a lick until ALL the air is out.
When a diesel is ran out of fuel, that is a golden opportunity to clean everything (tank, screens, ect) and change filters. Start off clean.
This is, as I mentioned, sort of a "generic" fuel system bleeding proceedure. Specific engine manufacturer instructions may be different. I'd suggest following them closely.
All it takes is running a diesel out of fuel ONE TIME, and most people will see that it never happens again. (and if you ever do it to an OLD diesel that's already hard to start, it'll make you go buy a new tractor......)