Results 1 to 3 of 3
  1. #1

    Default MF135 Perkins 2.152 motor

    I have a burnt MF135 diesel tractor and I have acquired an AS400 linciln welder fitted with a stationary perkins motor. The stationary motor is an A3.153 not the AD3.152 direct injection as fitted to the mF135. the crank on the stionary motor appears the same as the tractor ie it is not the extended splined crank. What problems am I likely to incur?
    The water pump is siezed and I intend to replace both the water pump and rediator with new from Bareco. If I mount the water pump on the lower bolt holes I think it will line up.

  2. #2
    Gold Member
    Join Date
    May 2012
    Posts
    294
    Location
    Gidgiegannup Springs, Western Australia
    Tractor
    Massey Ferguson 148 .Chamberlain Super 70. Caterpillar D4. Chamberlain 354 FEL.Toro 268 rideon kubota L2002fel

    Default Re: MF135 Perkins 2.152 motor

    Hi
    If the bolt pattern on the front is the same it will fit ok I would replace the clutch at the same time.
    the fuel supply lines are a little bit different but no real problem .
    check the injector pump setting by giving all details to a pump overhaul specialist they will be able to tell you if the engine will perform the same as the original,apart from that i cant think of anything else.
    Regards Hutch.

  3. #3
    Platinum Member civesnedfield's Avatar
    Join Date
    Jun 2007
    Posts
    600
    Location
    Central Maine
    Tractor
    2007 Mahindra 4530----1972 Massey Ferguson 1100

    Default

    You might want to be careful. A few of us were having a similar conversation about JD motors the other day. The motor that came from the welder might be for stationary use only. In other words the block may not be strong enough to handle the added stresses of being an engine block and a tractor frame at the same time.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2014 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.