PT-425 PROS & cons??

   / PT-425 PROS & cons??
  • Thread Starter
#71  
Re: PT-425 PROS & cons??

PRO: Power Trac Stability (PT Pucker)



Problem: Some newer TBN visitors may not know what "PT Pucker" is, or may be in dreadful fear of ever encountering the beast, or may be reluctant to get a PT for fear of it. I recently was visited by it while leveling the site for my new 30' x 38' Morton Building. I found it to be highly over rated and with some knowledge and practice can be tamed!!

DON'T TRY THIS AT HOME!! I loaded an ~750# sand filled roller into my LM Bucket to provide nearly 1000# on each front bar tire to nicely compact the newly placed clay fill.

Roller_TBN_a.jpg


Around and round, and up and down, I went with the bucket raised to clear the lawn as I came down the slopes. Then, while going down the slope I saw that I had missed a spot, so I instinctively pushed the Reverse Pedal and turned the Wheel to go back up and get it! That is when the PT Pucker struck!! Down went the Bucket, and up went the PT and I!!

Roller_TBN_b.jpg


After the initial surprise, and since I was WEARING MY SEAT BELT, I soon discovered that no harm had been done!! After gently climbing off, I found that the PT was solidly planted, and could not be rocked toward roll over even with the rear fully raised and the Wheel turned fully to one side!!

Roller_TBN_c_.jpg


Roller_TBN_d_.jpg


It is reassuring to know that even in seemingly disasterous situations the PT-425 keeps it's composure!!!!


PS: I usually drive with my left hand on the Suicide Knob, and with my right hand on the Joystick - ready to drop the load if needed to avoid the pucker.
It's all about learning the limits of your equipment, and not exceeding those limits! Sort of like driving on snow covered roads!!

/forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif
 
   / PT-425 PROS & cons?? #72  
Re: PT-425 PROS & cons??

Yup, that's the Han's pucker factor /forums/images/graemlins/blush.gif. Everyone who owns a PT knows about this. Your correct, easy to get out of (straighten the wheel) and your on your way. /forums/images/graemlins/grin.gif
PJ
 
   / PT-425 PROS & cons?? #73  
Re: PT-425 PROS & cons??

This also seems to be a good way to service the wheels as well as clean underneath and touch up any rust spots. /forums/images/graemlins/grin.gif

Cool pics.
 
   / PT-425 PROS & cons?? #74  
Re: PT-425 PROS & cons??

Yep! That be the PT Pucker. /forums/images/graemlins/wink.gif
 
   / PT-425 PROS & cons??
  • Thread Starter
#75  
Re: PT-425 PROS & cons??

con: Slow Bar Tire Leaks


My right front bar tire went from 11# to 8# each day, so I installed Victor brand Slime from Walmart.

After waiting a week, right front was still at 11#, but the left front was down to 9#, so I slimed that one!!

I only used 1 pint of Slime per tire!!

So far, the rears stay happily at 7#, but if need be, I'll Slime them!


PS: Using the supplied hose to install the Slime is made easier by deflating the front tire with the bucket raised, then lower the bucket to raise the tire off the floor as you squeeze the Slime bottle. The vacuum helps suck the Slime in more quickly.

/forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif
 
   / PT-425 PROS & cons?? #76  
Re: PT-425 PROS & cons??

<font color="blue"> Using the supplied hose to install the Slime is made easier by deflating the front tire with the bucket raised, then lower the bucket to raise the tire off the floor as you squeeze the Slime bottle. The vacuum helps suck the Slime in more quickly. </font>

Very helpful hint. Where were you two years ago when I sat there waiting for that bottle to drain? /forums/images/graemlins/tongue.gif /forums/images/graemlins/grin.gif
 
   / PT-425 PROS & cons?? #77  
Re: PT-425 PROS & cons??

On your pictures with the roller in the bucket it looks like you have reversed the rims to give a wider stance, and it looks like you have more clearance between the tires and the frame of the pt than on my older 422pt. Your pt being a new model is that the way it came or am I just not seeing it right?
 
   / PT-425 PROS & cons??
  • Thread Starter
#78  
Re: PT-425 PROS & cons??

"" Very helpful hint. ""


Thanks! It's just that because I am so lazy, I am always looking to do something better, easier, quicker, or nicer at less cost in time or labor!!

construction_.gif


/forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif
 
   / PT-425 PROS & cons??
  • Thread Starter
#79  
Re: PT-425 PROS & cons??

"" you have reversed the rims to give a wider stance ""


Yes! It makes a world of difference!!

Wide_TBN.jpg


/forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif
 
   / PT-425 PROS & cons??
  • Thread Starter
#80  
Re: PT-425 PROS & cons??

"" it looks like you have more clearance between the tires and the frame of the pt than on my older 422pt ""


OEM is the same - very little!

The extra clearance makes it easy to clean the mud and crud out from around the wheel motors for better cooling.

Great stability, as you can see!! It will now go places, and do things, comfortably, that I previously would have considered reckless, even on one of my ATV's!!

Rear_TBN.jpg


/forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif
 

Tractor & Equipment Auctions

County Line Spreader (A47809)
County Line...
Miva Ripper Tooth (A47809)
Miva Ripper Tooth...
2012 Chevrolet Silverado 1500 Crew Cab Pickup Truck (A45336)
2012 Chevrolet...
2014 ARISING INDUSTRIES ENCLOSED TRAILER (A47001)
2014 ARISING...
2008 ISUZU NPR Dump Truck (A46683)
2008 ISUZU NPR...
AerWay AWGHP-90-1C6-DB Pull-Behind Aerator (A45336)
AerWay...
 
Top